Manuals, brands, gE Manuals, security System, networX NX-4.
If this is not a new panel then you will need to default the panel programming back to factory default by doing the following: Enter * 8 Programming Code, when it asks for Device Address enter 0 followed by #.Type 0 and press #.Thank you for your help!If it was rejected then youll hear it beep 3 times.You will see Device Address.It will then ask for location.When finished; press # while the Ready LED is flashing Step 5 Enter Programming To enter into the panels programming section you will enter * 8 Programming Code You will then see Enter device address and then press #.If they are not displayed then press the corresponding numbers on windows 98 emulator vista the keypad to make them show.You will then press * * to skip the last two segments.
For instance you if you chose zone 9 you will type 9 * to put the device on zone.
Choose the zone number you want to program a label for and press # You will then see the Zone number displayed on the first line and then it is repeated on the second line with a cursor under the first character.
NetworX NX8 NX8E will have locations 25-36.Silences the pulsing keypad sounder for 5 seconds when a key kids wood eggs that crack is pressed.You will then press Exit Exit to exit programing.For example if you wanted to turn off resistor usage for a Zone Type 3 (Entry/Exit Delay 1) you would follow the steps below: Type * 8 Programming Code to enter programming At Choose device address # you will type 0 # Then you will.After entering the definition you will press * to advance to the next segment.You will enter 910 and then #.Depending on the model of Interlogix NetworX panel you have; the locations may differ. If there is a system problem, pressing *2, shows the service menu.Download the, interlogix Networx (NX4, NX6, NX8, NX8E) Quickstart Guide here.If you need to enter another code; repeat the process above.The controls for operation are: * key - Move cursor to the right/Accept character Cancel key Move cursor to the left Up arrow/Down arrow Change character cursor is on Stay key Insert Space Chime key delete characters Exit key Access NetworX vocabulary (Up/Down arrows choose.This option is called End of Line Resistor Defeat.From outside of programming type in * 8 Programming Code You will then be asked for the device number.
The common zone definitions are as follows: Hardwired Wireless Zones Wireless w/ Tamper Supervision Zones 3 - Entry/exit delay 1 17 - Entry/exit delay 1 with tamper 9 - Entry/exit delay 2 20 - Entry/exit delay 2 with tamper 5 Interior follower with auto bypass.
Select AN option: Programs special characteristics.
You will enter the first digit of your new Programming Code and then press * to advance to the next segment (digit).